Technical Requirements And Inspection Rules Of Tensioner

​

 1. The product requirements are manufactured according to the product drawings and technical documents approved by the prescribed procedures;

2. The characteristics of the tightening wheel are generally not specified, and are determined by the user in the drawing when there are special requirements;

3. The acceptance of the product needs to be tested by a special torsion testing machine for the tightening wheel;

4. The inspection of other items of the product shall be checked and accepted in accordance with the requirements of the buyer.

Tensioner is a tensioning device with drive

When the center distance of the belt cannot be adjusted, a tensioner can be used to tension the belt. The tensioner is generally arranged on the inside of the loose edge, so that the belt is only bent in one direction; at the same time, in order to ensure that the angle of the small pulley does not reduce too much, the tensioner should be installed as close as possible to the large pulley. The built-in automatic tensioner assembly is an ultra-compact design that combines an automatic tensioner and a pulley.

​